I just bought myself an Athearn UP SD40-2 #3765.I like it very much but I noticed thta my Cab is not firm on the shell its sticking up less then an inch.I was wondering has anyone else had this problem what do ya reccommend on how I can fix this error.Also where can I get some Number Boards for my SD40-2.Please let me know Thank You.Also what Detail Parts Company ya Reccomend to detail my SD40-2 I order from Walther’s but what company do ya think is a good company
I’ve had a similar problem after removing/refitting the cabs on my Dash 9s - I remove them to install the number boards/headlight glazing parts as there’s more room available to fit these with the cab off the shell. I found that sometimes the cab moulding doesn’t fit back quite right, sometimes a little “tweaking” with a file/craft knife is needed to get it to sit back in properly. I’d suggest removing (unclipping) the cab (follow the kit instructions) and refitting it.
As far as detail parts are concerned, Details West have a good range - take a look at the Dash 9s on their website (Athearn models superdetailed with their components) http://www.detailswest.com is the address.