If you have a Digitrax Zephyr and a UT-4 throttle, they each must have different addresses to work properly?
I didn’t and it caused a bit of grief.
Any other people out there have similar problems?
BB
not me bruce I still use dc
but I hope you get it worked out
we need more of your google u tube videos
Ken
Yeah, its because the two throttles are telling the locomotive to go two different speeds at one time and it can’t decide which one to use. I forgot to dispatch one loco off the ut4 and was running it with the Zephyr and it just kept stopping randomly. All it took was a change of throttle and it went for a few more minutes. It took us over an hour to figure this out on our club layout. We were running for the State Fair and my train kept stopping randomly. We reset the system three times and finally figured it out. Visitors dont like stopped trains.