Digitrax/JMRI Signaling Question

Model Railroader Electronics and DCC
1

I apologize in advance for this convoluted question but here goes…

I have a crossover (2 Main tracks with Crossovers) and would like some advice on how to wire signals and setup in JMRI. I have a Digitrax DCS210 system with an SE8C, BDL168, and Tortoise switch machines that are hooked up and operating. I am having trouble figuring out how to get started with the signaling. My goal is to have a CTC operation throughout the layout and decided to start with this. I have the crossovers done in JMRI Layout Editor with corresponding block sensors (which works!) My signals are Atlas/BLMA 4 head signal bridges. Basically I want get the singals wired correctly and be able to line movements through the crossovers.

Thanks everyone for any help!

-Ryan

2

Ryan,

I would strongly urge you to post your question on the JMRI user’s list at https://groups.io/g/jmriusers

In addition to the folks who actually write the JMRI code, lots of VERY experienced JMRI users hang out there. You will no doubt get the help you need.