Lacking a resistance soldering iron, what glue to use for detail parts.

Model Railroader General Discussion (Model Railroader)
1

I am attempting to add an Elesco feedwater heater to a Spectrum 2-10-2. I need some advice as to what glue to use for attaching the detail parts to the locomotive.

2

Well, a good contact cement (like barge glue) would do the job good.

3

BMMECNY,

You already got a lot of good advice in the thread You started in Layouts and Layout building…Review that thread…‘’ Brass detail parts recommended method of assembly".

Take Care! [:D]

Frank

4

Frank

I had forgotton about that thread until about half an hour ago when I was doing a search for a thread on the piping for the feedwater heater. Thank you for pointing it out though. I hadn’t read through all of the comments again.

Andrew