Need help using the NCE Power Cab

Model Railroader Electronics and DCC
1

Hi,

Can anyone tell me how to use the double digit functions on the number keypad for the NCE Power Cab? My son and I can’t figure out how to enter the function numbers from # 10 on in order to utilize some of the other decoder sounds.

Any information will be helpful.

Thanks, Mark

2

Only functions F10, 11, and 12 are programmed into the Power Cab. Holding down the SHIFT key while pressing the PROG/ESC key is F10, EXPN is F11, and 28/128 becomes F12.

Any functions higher than F12 require programming of the cab itself using the chart in the operator’s manual.

3

Apparently you have not read the manual. Go to page 19 and start reading. I just looked at it. Following instructions has always worked for me.

Rich