What are the dimensions between the holes on the universal throttle pocket by new rail models? I am trying to figure out fascia height. Thank you!
3 inches vertical and 3 3/8 horizontal.
Two screws will hold it securely if your fascia is too short.
Thank you! Perfect size, I wonder why I couldn’t find these measurements anywhere else.
I measured mine.
Because this place is the fountain of all knowledge, and other sites are merely poor reflections, shadows upon the wall in Plato’s Cave Train Room.
So while we’re at it, I put Velcro on the back of my throttles and the “other” Velcro on the sides of the legs supporting my layout. I do the same with my Rix Rail-it. On the sides of the legs, rather than on the fascia itself, the throttles don’t get brushed against when I pass by. Velcro doesn’t care what size your throttles are.