Just received my new Badger Anthem model 155 airbrush yesterday!
I will be killing a lot of cardboard this weekend with my new weapon.
Hello everybody. I have a athearn genesis 282 steamer that stalls. The problem is where the dcc wiring is located under the cab, one wire must be loose. How do you take the cab or shell apart to gain access to these wires or should I take it to a shop for this kind of repair? Thanks rambo1…
Look OUT. Here Kitty-Kitty…
haha! and a watch out to all the spiders living under my benchwork 
[quote]
Originally posted by rambo1
Hello everybody. I have a athearn genesis 282 steamer that stalls. The problem is where the dcc wiring is located under the cab, one wire must be loose. How do you take the cab or shell apart to gain access to these wires or should I take it to a shop for this kind of repair? Thanks rambo1…
rambo1 Seems like you may be in a thread that isn’t going to give you all you are looking for. How about posting you question as a new topic, or over in the DCC forum of the Atlas website?
http://forum.atlasrr.com/forum.asp?FORUM_ID=6 You’ll have to register to post, but that usually isn’t a problem.[:D]