HAND CONTROLLER HOLDER

Model Railroader Electronics and DCC
1

After getting a powercab I need something to hold the hand unit.Anyone come up woth a nice holder idea for holding these.Thanks for any help.Bob

2

http://www.walthers.com/exec/productinfo/501-40020

3

Hi!

I picked up the universal holders (like Walthers has) on Ebay, but most of the bigger internet stores have them as well. I’ve got two Digitrax DT-400 throttles and they sit in there just fine.

Mobilman44

4

That’s probably the best one out there and mounts in less than a minute.

5

Someone posted a message here a couple of weeks ago about a Mouse Holder that was very inexpensive compared to the Universal Controller holder or whatever Walthers calls it.

6

I use Velcro strips on the back of the throttle and the legs of my layout.

7

I stocked up on these, when Micromark had them on sale for $4.75
http://www.micromark.com/UNIVERSAL-CAB-HOLSTER,9137.html

Nick

8

I picked up some from mouseholder.com for $1.99 each. Made slight modifications to suit our NCE cabs. Used #2 sheet metal screws to mount.

I used a pair of wire cutters to cut the “V” a little wider for the cord at the bottom of the cab.

Rich

9

Thanks all.Great help.The walthers holder lookd great.That is my next buy.

10

Here is a home made one that is simple to make and looks sharp. Just change your design to match your particular throttle.

Terry in Sunny Florida

11

Is the one on the right for the pocket manual? [:D]