My grandson has an inexpensive Lionel starter set (Pennsylvania Flyer?) with a 4-4-2 locomotive. He’s young so it only gets set up at Thanksgiving/Christmas. We have it set up on a table in a simple figure-8. Last year I noticed that would speed up in the straight sections crossing the diamonds, then slow down in the curves. Even though it’s a small simple setup, I added a second set of feeder wires even though I doubted that it was an issue with being too far from the feeders.
Again this year we have it set up (while I’m visiting them) and have the same issue. The loco speeds up in the straightaway, enters the curve with decent speed, then quickly slows down as it nears the end of the curve. The difference in speeds is really significant.
I’ve cleaned the track (fast track) and the loco wheels/pickup rollers. I have 2 sets of feeder wires from the transformer. The loco is only pulling the tender and 4 cars.
Any thoughts on the cause? Is this this typical for department store Lionel sets?
I suppose it’s not critical. The speed slow down bothers me but doesn’t seem to phase the little guy. And while I think we have to run it too fast in the straight in order for it to make it around the curve, he likes that. I just thought I’d ask.
Thanks
Ed